Hop IP address ensures user network robustness. Hop IP address does not take effect, packets are forwarded according Next hop IP address in a traffic behavior. The redirect backup-nexthop command configures an action of redirecting packets to the backup Multiple times, only the latest configuration takes effect. If you run the ipv6 route re-search acl command.The IPv6 ACL number used in the ipv6 route re-searchĪcl command must be the same as that configured in the match acl ipv6 acl6-number command.If not, run the acl ipv6 command to create an IPv6 ACL that needs to be bound to the service Before running the ipv6 route re-search acl command, you can run the display acl ipv6 command to check whether the ACL. Packets generated on the device, you must run the rule (advanced ACL6 view) command to create an IPv6 ACL and then run the match acl ipv6 command to bind SPR to the IPv6 ACL. To enable the SPR function for IPv6 protocol packets generated onīefore applying the SPR function to IPv6 protocol This case, run the ip route re-search acl command When the quality of the voice transmission link changes, the serviceĭata link must be dynamically switched to ensure voice quality. These voice packets do not support the SPR function. On the device, the device converts voice signals on the phones into Run the description (service profile view) command.Ĭannot be enabled for IPv6 protocol packets generated on a device.įor example, when POTS phones are directly connected through FXS interfaces To set the parameter, run the wtr period command. Remaining time until traffic is switched from the backup To set this parameter, run the set cmi threshold command. To set this parameter, run the set jitter threshold command. To set this parameter, run the set delay threshold command. Table 8-235 Description of the display smart-policy-route service-map command To set this parameter, run the policy-based-route command. deny: indicates PBR is disabled for matched packets.permit: indicates PBR is enabled for matched packets.Parameter, run the apply ip-address default next-hop command. Set this parameter, run the apply default output-interface command. Run the apply ip-address next-hop (policy-based route view) command.ĭefault outbound interface for sending packets. Parameter, run the apply output-interface command. The apply ip-precedence (policy-based route view) command. Parameter, run the if-match packet-length command. Matching rules based on IP packet length. Parameter, run the if-match acl (policy-based route view) command. Parameters, run the policy-based-route command. Table 8-229 Description of the display ip policy-based-route setup command If two next hops have been configured and then another next hop is configured, this next hop replaces the first configured next hop but not the second configured next hop. You can use the apply ip-address next-hop ip-address1 track ip-route ip-address2 or apply ip-address next-hop (policy-based route view) command to specifyĪ maximum of two next hops for packet forwarding in local PBR. The next-hop IP address specified for packet forwarding cannot be a local IP address. If the IP address is unreachable, the configured next hop does not take effect, and the device checks whether a backup next-hop IP address has been configured.If the IP address is reachable, the configured next hop takes effect, and the device forwards packets according to the configured next hop.Then the device detects whether the configured IP address of the route associated with the next hop in PBR is reachable. You can configure association between next hop and route. Reach the destination if the packets are forwarded based on local PBR. When a fault occurs on the remote link, packets cannot However, specifying a next-hop IP address can only detect whether the direct link is available. In local PBR, a next hop is specified for packet forwarding.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |